Contec CONPROSYS CPS-MG341G-ADSC1-930 Reference Manual page 78

Item
Maximum input rating
Input impedance
The number of channels
Channel switching rate
Conversion rate
Data buffer
Resolution
Non-Linearity error *6
Isolation/Resistance
Connector
Applicable wire
LED
LED
Switch
RTC
Power supply *7 Rated input voltage
Input voltage range
Power consumption
Connector
Applicable wire
Surge protection element
V+ - V-, V- - FG
Physical Dimensions (mm)
Weight
Installation method
OS
*1 The LAN ports are independent, which makes it possible to split the network segment.
*2 Data 0 corresponds to High level and Data 1 corresponds to Low level.
*3 The default setting is for an external circuit power supply. With a software command, it can be
switched to the built-in power use.
*4 Response time of opto-coupler
*5 Switching time of Inter Channel
*6 The non-linearity error means an error of approximately 0.07% occurs over the maximum range
at -20 °C and +60 °C ambient temperature.
*7 Use power cable within 3meters.
—
Appendix
CPS-MG341G-ADSC1-930 Reference Manual (Hardware)
30mA
250Ω
Current Input 2ch
3msec/ch (Max.) *5
The sampling interval differs by the software programmed
by the user.
None
12bit
±10LSB
Bus Isolation /500VDC, Inter Channel Isolation /200V
2-piece 3.5mm pitch 3-pin terminal (AI+, AI-, SG)
AWG28 - 16
AI0 - AI1 (Yellow)
Power (Green)/Status 1 (Green)/Status 2 (Red)
Reset SW, Shut Down SW, Full Duplex/Half Duplex Switching
SW
RTC built-in (battery life :10 years or more at 25°C) lunar
inequality ±15sec (at 25°C)
12 - 24VDC
10.8 - 30VDC
12V 0.8A (Max.), 24V 0.4A (Max.)
2-piece 3.5mm pitch 3-pin terminal (V+, V-, FG)
AWG24 - 16
Interactive TVS diode
Stand off voltage : ±30V, Peak pulse power : 400W (1msec)
188.0(W)×78.0(D)×30.5(H) (No projection included)
350g
Quick mounting on the 35mm DIN rail, Mounting on the
wall using the screws *8
Linux kernel 3.2
— 78 —
—
Description