Gallagher M6000i Instructions Manual page 11

Gallagher 3E5260 M6000i/M12000i Energizer User Manual
Step 3. Connect the fence
a) Connect the energizer's red output ( ) terminal to the fence using
Underground Cable (G627). Remove 5cm (2") of plastic coating from one end
of the cable. Unscrew the red (FENCE) terminal and insert the wire through the
terminal slot. Screw the terminal closed, ensuring the wire is firmly clamped.
b) Attach the other end of the cable to the fence using a Joint Clamp (G603).
For instructions on fence installation see the Gallagher Power Fence™ Manual or go
to www.gallagher.com.
Step 4. Turn the Energizer On
a) Plug the energizer into a power outlet and switch ON.
b) Check that the Power On LED on the front of the energizer is green.
c) Re-attach the orange terminal cover.
IMPORTANT: Readings will change as the fence conditions change. This is the
Energizer monitoring the fence and Energizer performance. Read the section
"Understanding your Energizer Controller" (p.13) for a complete understanding of
the display and alarms.
11