Advertisement
Available languages
Available languages
R R E E A A R R P P A A N N E E L L
All Inputs and Outputs are electronically balanced (Pin 2 positive). Each Input or Output has three connector
options: XLR, 1/4" and 3-pin Euro. When a mono, TS 1/4" phone jack is inserted, this input (or output) becomes
unbalanced. Whenever possible‚ balanced connections are preferred.
( ( 3 3 4 4 ) ) I I E E C C M M a a i i n n s s C C o o n n n n e e c c t t o o r r
This is a standard IEC power connector. An AC mains cord having the appropriate AC plug and ratings for the
intended operating voltage is included in the carton.
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not
have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded
properly. To prevent the risk of shock or fire hazard, always be sure that the VSXII crossover and all
associated equipment are properly grounded.
( ( 3 3 5 5 ) ) C C h h a a n n n n e e l l 1 1 I I n n p p u u t t
This is Channel 1 balanced input in stereo MODE. In mono MODE this is the unit's only operable input.
( ( 3 3 6 6 ) ) C C h h a a n n n n e e l l 1 1 L L o o w w O O u u t t p p u u t t
Channel 1 low-pass frequency band output in stereo MODE. In mono MODE this is the unit's only LOW
frequency output.
( ( 3 3 7 7 ) ) C C h h a a n n n n e e l l 1 1 H H i i g g h h O O u u t t p p u u t t
Channel 1 high-pass frequency band output in stereo MODE. In mono MODE this output is not used
(inoperable).
( ( 3 3 8 8 ) ) S S u u b b w w o o o o f f e e r r O O u u t t p p u u t t
Yields only the low frequency signals through a separate, fourth-order low-pass filter with a corner frequency
(-3 dB) at 100 Hz and a 24 dB/octave slope. Samples the Channel 1 and Channel 2 signals before the crossover
filters in stereo MODE or just Channel 1 signal in mono MODE. The 40 Hz low cut filters affect this output.
( ( 3 3 9 9 ) ) C C h h a a n n n n e e l l 2 2 I I n n p p u u t t
This is Channel 2 balanced input in stereo MODE. In mono MODE this input is not used (inoperable).
( ( 4 4 0 0 ) ) C C h h a a n n n n e e l l 2 2 L L o o w w O O u u t t p p u u t t
Channel 2 low-pass frequency band output in stereo MODE. In mono MODE this is the unit's single channel MID
frequency output.
All manuals and user guides at all-guides.com
9
Advertisement
