Advertisement
___
Mount the YELLOW (RDY) LED
Insert the YELLOW LED into the holes for the RDY LED (it may be clear, rather than yellow
or orange). Note that the LED may be clear rather than yellow. Make sure that the LONG
lead is in the hole maked "+". Double-check to make sure! Turn the board over and solder the
leads to the board. Trim the leads flush.
Mounting the Resistors
The resistors are going to be mounted vertically, so you will need to bend one lead back
against the body of the resistor in order to do this. They aren't polarized, but we like to have
all of the color bands facing up to make it easier to identify them (the fourth band is a
"tolerance" band and will probably be the same color on all of the resistors).
Advertisement
