Advertisement
___
Mount the pizo buzzer
Insert the pizo buzzer into the holes on the board. It is not polarized, so it doesn't matter which
way you mount it. Turn over the board, and solder the leads to the pads. Trim the leads flush.
___
Mount the resonator
Insert the 16.000 MHz resonator into the holes on the board (marked "XTAL"), making sure
that it seats completely. You may need to use some masking tape to hold it in place. It is not
polarized, so it doesn't matter which way you mount it. Turn over the board and solder the
leads, and trim if necessary.
Advertisement
