Advertisement
___
Mount the 10K resistors (brown-black-orange bands)
Bend one lead back on each of the six 10K resistors. Locate their positions on the board: two
near the bottom left of the board, one at the upper left corner of the board, one in the upper side
of the board between the two .1 uF capacitors, and two just to the left of the optoisoltors.
Iinsert the resistors in the board. Turn over the board and solder the resistors in place,
trimming the leads flush afterwards.
___
Mount the 820 ohm resistors (grey-red-brown bands)
Bend one lead back on each of the two 820 ohm resistors. Locate their positions on the board,
just to the right of the optoisolators, and insert the resistors in the board. Turn over the board
and solder the resistors in place, trimming the leads flush afterwards.
Advertisement
