Page 1
OPERATING MANUAL BATCH FREEZER INSTALLATION OPERATING, MAINTENANCE AND CLEANING MANUAL CB-100 Countertop World’s Best Built Batch Freezers – 100% Made in the U.S.A. by the People Who Invented Them!
Page 3
Section 1: UNPACKAGING When your shipment arrives, please inspect it very carefully. Look particularly for damage to the box covering it. If it looks crushed, cut or punctured, have the freight driver wait until you can cut the box off, and inspect the machine itself. Also, look for damage to the wooden skid itself.
Page 7
Section 2: OVERVIEW Your new model CB100 Countertop Batch Freezer is a self- contained air-cooled unit that is designed to sit on any countertop and be easily moved for cleaning. It runs on standard residential/commercial 115V service, and comes equipped with a plug for such.
Page 8
Section 3: OPERATION The normal sequence of operating the CB100 is as follows: 1. Insert a clean, sanitized (See Section 4) freezing tub into the freezing cylinder, making sure the rim of the tub engages all 4 of the round drive lugs and that the rim sits flush with the top surface (See Figure 3-1).
Page 9
approximately another 1/4" and stop on its rubber bumper. 7. Once the dasher is spinning, turn the freezing timer to 20 minutes. The refrigeration will start, and continue until the timer either times-out, or you manually twist it to the "0" position.
CB100 Batch Freezer has very few parts to clean and sanitize. You will need to have a commercial sanitizer on hand at all times. Emery Thompson recommends Purdy Products "SteraSheen Green Label" sanitizer and cleaner, which was included with your machine. It is a powder that is dissolved in water.
Page 14
into the freezing cylinder! Once the outside of the tub is completely dry, it can be inserted into the freezing cylinder, and locked onto the 4 drive pins. At this point, you are ready to add mix/ingredients, and begin. Keep in mind: the cleaner you work, the easier cleanup will be. Rather than a sponge or rag, use disposable paper towels.
Section 5: CARE and MAINTENANCE Your model CB100 requires very little in the way of care and maintenance. There are some functions of the machine that bear paying attention to. 1) Airflow - your machine uses airflow from its surroundings to extract heat from each batch of product you make.
If for some reason the cord becomes damaged or frayed, or the plug does, have an electrician replace the entire cord. You can purchase this part from Emery Thompson. 5) General cleanliness - aside from the normal day-to-day cleanup...
Page 21
Caution: This warranty is valid only if required service is provided by an authorized agent of Emery Thompson Machine and Supply Company or person or persons directly authorized by Emery Thompson to perform the necessary repairs. Emery Thompson can be reached at 718-588-7300-factory, 352-796-0720-fax or STEVE@EMERYTHOMPSON.COM...
Page 22
(located on rear panel of machine). Emery Thompson Machine and Supply Company, Inc. reserves the right to make design changes, or to make additions to, or improvements on its products without imposing any obligation on itself to make such changes on its products previously manufactured.
Page 23
NO DISTRIBUTOR, DEALER OR OTHER PERSON IS AUTHORIZED TO MAKE ANY COMMITMENT OR ASSUME ANY LIABILITY ON BEHALF OF EMERY THOMPSON MACHINE AND SUPPLY COMPANY, INC. BEYOND THIS WARRANTY. THERE ARE NO WARRANTIES, WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF.
Page 24
Our videos can be found at EmeryThompson.com. From our family to yours let us welcome you to the Emery Thompson family and help you achieve your ice cream dreams! Call today 718-588-7300 ~ 23 ~...
Need help?
Do you have a question about the CB-100 and is the answer not in the manual?
Questions and answers