Advertisement
As a mono-bridged amplifier:
See Fig. 8.0 for the connection of the power supply and the speaker. Make sure that the impedance of the
connected speaker is not less than 8 ohms.
MIN. 8 Ohm
+
-
Fig 8.0
IMPORTANT: Always connect the outputs first, before the power supply is switched on.
If the amplifier is to be used as a free-standing unit, it may be attached by means of M4 hexagonal bolts and
the corresponding slots in the heat sink.
K4004
+LS
BRIDGE
LS
INPUT
GND
MONO BRIDGE : 100W
+V
GND
-V
Use & connection
RMS
POWER
SUPPLY
APS200
+V
GND
-V
13
Advertisement
