Installation - Beko DSF5240M00W User Manual

3

Installation

3.1. Right place for installation
Contact the Authorized Service for
the product's installation. To ready
the product for installation, see the
information in the user guide and make
sure the electric and water utilities are
as required. If not, call an electrician
and plumber to arrange the utilities as
necessary.
B
WARNING: The manufacturer assumes
no responsibility for any damage
caused by the work carried out by
unauthorized persons.
B
WARNING: The product's power
cable must be unplugged during
installation. Failure to do so may result
in death or serious injuries!
A WARNING: If the door span is too
narrow for the product to pass,
remove the door and turn the product
sideways; if this does not work,
contact the authorized service.
• Place the product on a flat surface to
avoid vibration.
• Place the product at least 30 cm away
from the heater, stove and similar
sources of heat and at least 5 cm away
from electric ovens.
• Do not expose the product to
direct sunlight or keep in damp
environments.
• The product requires adequate air
circulation to function efficiently.
• If the product will be placed in an
alcove, remember to leave at least 5 cm
distance between the product and the
ceiling and the walls.
• Do not install the product in
environments with temperatures below
-5°C.
3.2. Attaching the plastic wedges
Use the plastic wedges in the provided
with the product to provide sufficient
space for air circulation between the
product and the wall.
To attach the wedges, remove the
1.
screws on the product and use the screws
provided with the wedges.
Refrigerator / User manual
Attach 2 plastic wedges on the
2.
ventilation cover as shown in the figure.
3.3. Adjusting the stands
If the product is not in balanced position,
adjust the front adjustable stands by
rotating right or left.
3.4. Power connection
A
WARNING: Do not use extension or
multi sockets in power connection.
B
WARNING: Damaged power cable
must be replaced by Authorized
Service.
C
When placing two coolers in
adjacent position, leave at least
4 cm distance between the two
units.
Our firm will not assume responsibility
•
for any damages due to usage without
earthing and power connection in
compliance with national regulations.
The power cable plug must be easily
•
accessible after installation.
Connect the refrigerator to an earthed
•
socket with 220-240V/50 Hz voltage.
The plug must comprise a 10-16A
fuse.
Do not use multi-group plug with or
•
without extension cable between the
wall socket and the refrigerator.
39 / EN