Page 1
THANK YOU We appreciate the trust and con dence you have placed in PHI VILLA through the purchase of our product. We strive to continually create quality products designed to enhance your home. Visit us online to see our full line of products available for your home improvement needs.
Table of Contents 12-14 Table of Contents Operation Instructions Warnings & Important Safety Information Care and Maintenance Speci cation & Package Contents Troubleshooting Safety Information Warranty 9-11 Assembly instructions WARNING: For Outdoor Use Only. INSTALLER: Leave this manual with the appliance. Installation and service must be performed CONSUMER: Retain this manual for future reference by a quali ed installer, service agency, or...
Page 3
IMPORTANT SAFETY INFORMATION The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1 NFPA 54; National Fuel Gas Code; Natural Gas and Propane Installation Code, CSA B149.1; or Propane Storage and Handling Code, CSA B149.2, as applicable.
IMPORTANT SAFETY INFORMATION (About Propane Gas) The propane gas supply cylinder to be used must be constructed and marked in accordance with the U.S. Department of Transportation (D.O.T.) Speci cations for propane Gas Cylinders, or the Standard for Cylinders, Spheres and Tubes for Transportation of Dangerous Goods and Commission, CAN/CSA-B339, as applicable.
Page 5
PACKAGE CONTENTS HARDWARE CONTENTS Bolt (M6 x 5 mm) Caster Caster with locking device Ground fixer PART DESCRIPTION QUANTITY Metal shield Glass xture Wide glass Narrow glass Base Door Weather cover Foot glider (PRE-ASSEMBLED) Bolt (M6 x 5 mm) Caster Caster with locking device Ground xer NOTE: Hardware not shown to actual size.
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. This manual contains important information about the assembly, operation and maintenance of this patio heater. General safety information is presented in these rst few pages and is also located throughout the manual. Keep this manual for future reference and to educate new users of this product.
Page 7
SAFETY INFORMATION DANGER • CARBON MONOXIDE HAZARD. • This heater is a combustion appliance. All combustion appliances produce carbon monoxide (CO) during the combustion process. This product is designed to produce extremely minute, non-hazardous amounts of CO if used and maintained in accordance with all warnings and instructions.
Page 8
SAFETY INFORMATION WARNING WARNING BURN HAZARD Certain materials or items, when stored under the • Never leave heater unattended when hot or in heater, will be subjected to radiant heat and could use. be seriously damaged. • Keep out of reach of children. CAUTION SERVICE SAFETY •...
ASSEMBLY INSTRUCTIONS 1. Side place the product base (E) on a non-abrasive at surface to prevent Figure 2 scratching, unscrew the foot gliders (H) and remove from the base (E). Line up the hole on the ground xer (DD) with the corresponding holes on the base (E), then insert the bolt on foot glider (H) into the holes and hand tighten them clockwise.
Page 10
ASSEMBLY INSTRUCTIONS Figure 5 4. Cover and clamp the four narrow glass (D) with glass xture (B) carefully. Afterwards, tighten the bolts (AA), but not tighten too much to avoid the glass pieces being damaged (See Figure 5). 5. Insert the four wide glass (C) into the "L" clips which have been Figure 6 welded together with table top, then attach them with bolts (AA) using the Phillips screwdriver (See Figure 6).
Page 11
ASSEMBLY INSTRUCTIONS 7. Place the gas cylinder into the cylinder holder. Secure the cylinder Figure 8 by tightening clockwise the retention point found on the cylinder holder, so that the cylinder cannot move from side to side or fall down. Connect the regulator, screw the black handle clockwise to tighten, turn the black handle counterclockwise to remove.
OPERATION INSTRUCTIONS Battery Make sure the control knob is in the “OFF” position. Unscrew the push button cap on the ignitor module located on the control panel to access the battery compartment. The ignitor module requires one AAA size battery. BATTERY IS NOT INCLUDED. WARNING: 1.
Page 13
OPERATION INSTRUCTIONS gas valve / regulator hose connection (Figure 13) inlet tube / bellows connection (Figure 14) To perform a leak test: 1. Make 2~3 oz. of leak solution by mixing one part liquid dishwasher detergent and three parts water. Noted: make sure control knob is “OFF”.
OPERATION INSTRUCTIONS Observe Flame Height When Lit: The burner will display blue and yellow ames. These ames should be a blue / yellow color between 15~20 in. height (See Figure 16). These ames should not be yellow or produce thick smoke. This would indicate an obstruction of air ow through the burners.
TROUBLESHOTTING Problem Possible cuase Corrective action Wait until gas cylinder warms up and The gas cylinder is frosted over. becomes unfrosted. The burner An opening is blocked. Clear the blockage. will not ignite. The control knob is not in the “ON” position. Turn the control knob to the “ON”...
WARRANTY Heater Burner, all mechanical parts and ttings to control panel and burner assembly, and all patio heater tops that are not cast aluminum are warranted for a period of one (1) year from original date of purchase, against defects in material and or workmanship. Rust is not cov- ered.
Need help?
Do you have a question about the E02GS021 and is the answer not in the manual?
Questions and answers