Table of Contents
Advertisement
All manuals and user guides at all-guides.com
DOLBY PRO LOGIC
Dolby Pro Logic
This state of the art Dolby Pro Logic mini
system enables you to experience and
enjoy a Home Cinema sound ambience. The
Pro Logic system allows more accurate
definition of the individual sound sources.
It produces greater sound separation
between channels and provides pinpoint
sound localization. Pro Logic provides four
sound outputs: Left, Center, Right and
Surround (Rear). Front sounds are produced
from the pair of Left and Right speakers
and a Center speaker. The surround sound
is reproduced by two speakers placed at
the rear of the listening area. Although the
surround sound is monaural (single-source),
a pair of speakers is necessary to produce
the correct diffused sound.
This Pro Logic decoder enables you to
decode the following modes: Dolby
Surround, Center Phantom, Dolby 3
Stereo or normal Stereo .
Setting up the Dolby Pro Logic
system
You must set up the system properly in
order to enjoy the Home Cinema sound to
the fullest. First, connect the speakers.
5-Speaker Connection
• Front speakers: Connect the front
speakers.
• Center speaker: Connect the center
speaker.
8
pg 01-31/P88/22-Eng
8
• Rear (surround) speakers: Connect
Center Speaker
either the wired rear surround speakers
For the best sound, place the center
or a pair of wireless rear speakers (not
speaker at the same height as the left and
supplied) to the SURROUND OUT
right speakers. Place the center speaker
terminals.
directly above or beneath the television.
Rear (surround) Speakers
The surround speakers should be placed at
CENTER
normal listening ear level or mounted on
the wall at the back of the room. Most
REAR
SURROUND
FRONT
important, experiment when placing the
REAR
FRONT
surround speakers in order to obtain the
LEFT
LEFT
best sound.
REAR
FRONT
RIGHT
RIGHT
Test Tone
This feature enables you to adjust the Front
Left, Front Right, Center and Surround
Positioning the Speakers
Sound levels of the respective speakers in
To get the best surround sound effect,
Dolby Pro Logic mode.
place the speakers as follows.
You must sit at the ideal sitting
CENTER
position and use the remote control to
SPEAKER
SUB-
MINI HIFI
FRONT
WOOFER
SYSTEM
FRONT
perform this operation.
LEFT
RIGHT
TV
1 Press CD, TUNER, TAPE or AUX to
switch on the system.
2 Press TEST TONE.
SURROUND
SURROUND
LEFT
RIGHT
™ A test signal is generated; it will
Front Left and Right Speakers
™ "TEST TONE" followed by
For the best sound, place the Left and Right
speakers at an angle of approximately 45
degrees to the listener. If the speakers'
magnetic field affects the television
picture, increase the distance between the
™ The test signal will last for about 90
TV and the speakers.
3 Press
BALANCE L
to adjust the
sound of the
front left
speaker.
™ The display will show
"BAL L +XX".
4 Press BALANCE R to adjust the sound
of the front right speaker.
™ The display will show
"BAL R +XX".
5 Press CENTER + or - to adjust the
sound of the center speaker.
™ The display will show either
"CENT +XX or -XX".
6 Press REAR + or - to adjust the
sound of the surround speakers.
™ The display will show either
"REAR +XX or -XX".
7 Adjust the sound of all
the speakers until they
are equal. When you
are satisfied with the
setting, press TEST
TONE again to switch
off the test signal.
move through the Left, Center, Right,
Note:
and Surround speakers, in that order.
– It is advisable to set the speakers' level
at normal listening level. " XX " denotes
"ADAPT BALANCE, CENTER
the sound level.
AND REAR LEVEL" will be
displayed.
seconds.
3/6/00, 1:26 PM
DPL TEST TONE
BALANCE
L
R
CENTER
REAR
-
+
-
+
REPEAT
S
DPL
TEST TONE
BA
L
CENTER
R
+
3139 116 19721
Advertisement
Table of Contents
