LG WM3360H CA Series Service Manual page 18

No. Process
A. Intermittent • To reach the correct set speed, the motor rotates clockwise and
spin
• If the water level frequency is lower than 23.0 kHz,
B. Rinse • In this process, the remaining water during washing process is
spin
• Removing suds process is in active mode at this cycle.
C. Remaining • After spin finishes, the drum rotates by remaining spin power until it
spin
• This process is overlapped with next process.
D. Rinse water • Water supply for rinse process.
supply
E. Rinse • Rinsing process.
F. Last • After spin finishes and power is not supplied to motor, the drum
drainage
• If rinse hold is selected, the drainage is not proceeded after rinse
G. Disentangling • The same as item 9.
Intermittent spin • The same as item A.
H.
I. Main spin1 • The same as item B.
J. Main spin2 • At the end of a main spin, the spin speed will reach the selected rpm.
K. Remaining spin • The same with item C.
L. Disentangling • After spin finishes, disentangling starts to remove unbalanced
M. End • After 'end' signal is displayed, it stays for 8 seconds and power is
• After door switch is off, end signal is displayed in the case of
All manuals and user guides at all-guides.com
counterclockwise directions after spin process starts.
a washer senses suds and starts suds removal process.
extracted and the selected speed is kept.
stops. Motor power is off.
rotates by remaining spin power.
finishes.
laundry.
automatically turned off. (Auto type door switch)
manual type and it takes around 2 minute to turn off door switch.
17
Explanation