Summary of Contents for Heart of House HOH Hadlow 381/5931
Page 1
HOH Hadlow Solid Oak Pair Chairs Assembly Instructions - 381/5931 Please keep for future reference Dimensions - Chairs Width - 44cm Depth - 52cm Height - 86cm Important – Please read these instructions fully before starting assembly Issue 1 - 23/12/14...
Page 2
Safety and Care Advice Important – Please read these instructions fully before starting assembly &KHFN \RX KDYH DOO WKH 'R QRW VWDQG RU SXW ZHLJKW RQ :H GR QRW components and tools listed on WKH SURGXFW GXULQJ DVVHPEO\ recommend the pages 2 and 3.
Page 3
Components - Panels If you have damaged or missing components, call the Customer Helpline: 0845 640 0800 Please check you have all the panels listed below right left Left & right side apron x 2 (34.2 x 5.5cm) Front frame x 2 (43 x 43.5cm) right left...
Page 4
Components - Fittings 16mm Nut x 8 M6x80mm Bolt x 8 20mm Barrel nut x 8 15mm Screw x 16 Fly washer x 8 40mm screw x 12 Tools required Ruler/tape Phillips screwdriver measure (medium) Ruler - Use this ruler to help correctly identify the screws 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170 The screws length is measured from the head to the point (30mm screw shown).
Page 5
Assembly Instructions Step 1 Fitting bolts Insert barrel nuts into back as shown. Screw bolts into barrel fully. Insert barrel nuts into front frame shown. Screw bolts into barrel fully.
Page 6
Assembly Instructions Step 4 Step 2 Attaching apron Position left apron with its end marked ‘LB’ onto back , as shown. Slide fly washer into bolt . Loosely secure nut to bolt using wrench Note: Do not fully tighten the nut at this point in time.
Page 7
Assembly Instructions Step 2 (cont’d): Position right apron with its end marked ‘RB’ onto back as shown. Slide fly washer into bolt . Loosely secure nut to bolt using wrench Note: Do not fully tighten the nut at this point in time. Step 3 Attaching rails Insert the end marked ‘L’...
Page 8
Assembly Instructions Step 4 Attach front frame Attach front frame to the aprons and side rails Slide fly washers into bolts of front frame . Loosely secure nuts to bolts using wrench Then fully tighten all nuts...
Page 9
Assembly Instructions Step 5 Attaching rails Place the chair assembly upside down on a covered table top. Fix side rails middle rail using screws Step 6 Attaching seats Remove chair frame and with its place seat bottom facing up on the covered table top.
Need help?
Do you have a question about the HOH Hadlow 381/5931 and is the answer not in the manual?
Questions and answers