Charging The Battery - Bissell EASY SWEEP 15D1 series User Manual

A
ssembly

Charging the battery

1. When completely charged, the
EasySweep provides up to 45 minutes of
cleaning time.
2. When charging for the first time, allow
to charge uninterrupted for at least 16
hours. Thereafter, charge at least 16
hours to fully renew the EasySweep bat-
tery. The charging indicator light will
illuminate when properly connected and
will not turn off when fully charged.
Note: The Power Switch must be in
the OFF position when charging.
3. Decreased operating time may indicate
the battery has built up a resistance. To
recharge, first completely exhaust the
battery, recharge it, and then exhaust it
again before recharging a second time.
This procedure may be required more
than once.
4. When charging is complete, be sure to
unplug the EasySweep from the charger.
O
perations
Using your EasySweep
The EasySweep is a quick and easy
way to clean your bare floors, low pile
rugs and carpet.
1. Tip back the handle into typical use posi-
tion and gently tap the power switch on
the sweeper with your foot.
Note: The unit will continue to run
even if the dirt container door is
not closed.
2. The handle swivels for easy maneuvering
to clean your bare floors, low pile rugs
and carpet.
3. When done, turn off the unit by gently
tapping the power switch with your foot
and store for the next use.
w w w . b i s s e l l . c o m
Attention:
If your battery still fails to recharge
or does not hold a charge of normal
duration, call:
BISSELL Consumer Services
1-800-237-7691
Monday – Friday 8 a.m. – 10 p.m. ET
Saturday 9 a.m. – 8 p.m. ET
Or visit our website at:
www.bissell.com
WARNING:
EasySweep will not pick up cray-
ons, marbles, and other large or
hard objects.
8 0 0 . 2 3 7 . 7 6 9 1
5