Nice Moon MOMB Instructions And Warnings For Installation And Use page 10

During the execution of the procedure, press the "P" key (fig. 4) to select the
new command (during the procedure, every time the key is pressed the next
command is selected; see Table 5).
The procedure concludes when the "L1" LED (fig. 4), stops flashing or when
the card is passed to confirm the new command.
N° of flashes Command
1 flash + pause Step-by-Step (command n° 1 factory-set)
2 flashes + pause Opening
3 flashes + pause Closing
4 flashes + pause Partial open (command n° 2 factory-set)
5 flashes + pause Stop
6 flashes + pause Courtesy lamp
• Procedure for changing command n° 1, with card programmed in
STATIC 1 mode
01. Pass a valid card in front of the reader to activate command n° 1
02. The "L1" LED (fig. 4) emits a number of flashes equal to the type of com-
mand set, followed by a pause
03. Press the "P" key (fig. 4) to select the new command (every time key P is
pressed, the L1 LED flashes an extra time)
04. Then pass the card again
05. At this point, the new command is memorised and activated
• Procedure for changing command n° 2, with card programmed in
STATIC 2 mode
01. Pass a valid card in front of the reader to activate command n° 2
02. The "L1" LED (fig. 4) emits a number of flashes equal to the type of com-
mand set, followed by a pause
03. Press the "P" LED (fig. 4) to select the new command (every time key P is
pressed, the L1 LED flashes an extra time)
04. Then pass the card again
05. At this point, the new command is memorised and activated
8 – English
TABLE 5
• Procedure for changing command n° 1, with card programmed in
DYNAMIC mode
01. a) place a valid card near to the reader; this will emit an acoustic sound
b) hold the card still; the command will be activated after 1 second;
02. The "L1" LED (fig. 4) emits a number of flashes equal to the type of com-
mand set, followed by a pause
03. Press the "P" key (fig. 4) to select the new command (every time key P is
pressed, the L1 LED flashes an extra time)
04. a) place the card near to the reader again; this will emit an acoustic sound
b) hold the card still until another acoustic tone (beep) is emitted)
05. At this point, the new command is memorised and activated
• Procedure for changing command n° 2, with card programmed in
DYNAMIC mode
01. a) place a valid card near to the reader; this will emit an acoustic sound
b) move the card away and place it near to the reader again within 2 sec-
onds to activate command;
02. The "L1" LED (fig. 4) emits a number of flashes equal to the type of com-
mand set, followed by a pause
03. Press the "P" key (fig. 4) to select the new command (every time key P is
pressed, the L1 LED flashes an extra time)
04. a) place the card near to the reader again; this will emit an acoustic sound
b) move the card away and place it near to the reader again within 2 seconds
05. At this point, the new command is memorised and activated