Kelvion TEC1 Installation & Maintenance page 12

UNPACKING
KEC / KME
UNPACKING ON ALL KEC AND KME MODELS
1. Remove the box/crate packaging.
2. On KEC units remove the drain tray by removing the four fixings and then fit the hexagonal drain connection and gasket into the hexagonal well inside the
drain tray. Hand tighten this assembly using the knurled nut on the outside. When the cooler is in position ensure that the drain pan is dropped down into the
operating position before tightening its fixings. The KME units will have a cable tie fixing the drain tray along the side of the unit.
3. Place into position using the location guidance.
UNPACKING ON ALLTEC MODELS
The location of the unit should be carefully selected to ensure that:
4. Air distribution from the cooler is not adversely effected by obstructions and is appropriate for the size and shape of the room, optimum air distribution
should be targeted. Product loading must be in accordance with good refrigeration practice.
5. Air entering the cooler is not obstructed.
6. The unit must be installed level in both directions.
7. Maintenance access should be considered when locating the product, including adequate space for heater withdrawal when appropriate.
8. The unit is not subjected to physical loads.
TEC