Troubleshooting - Raider RD-KMD02 User Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 11
16
www.raider.bg
■ It is the operator to move downwind. k If your
eyes or mouth sprayed with chemical
wash them with clean water and then go to the
doctor.
■ If you get a headache or you dizzy, stop work
immediately and see a doctor immediately.
■ For your safety, spraying / aerial spraying must
be carried out by strictly following the instructions of
the very chemicals used in agriculture.

TROUBLESHOOTING

1. The engine starts hard or may not ignite.
• Make sure the light-ing candle gives a spark.
• Remove the candle and let the outside pole
mass.
• Pull the starter rope and see if the terminals of
the spark plug spark occurs.
• Do not touch the metal part of the spark plug to
prevent electrocution. See fig.15
Problem
No spark spark plug
Reason
Solution
spark device is
dried
damp
The distance
Adjust
between the
gap of
poles of the
0.6-0.7
candle is too
mm
large or too
small
spark plug
No spark
electric
magnet
electric
No spark
magnet
The
degree of
compression
and fuel
supply are
normal
Fuel supply
Unstable
is normal,
engine
but the
degree of
compression
is bad
No supply of
fuel from the
carburetor
2. Engine output is insufficient.
Problem
Reason
Compression
Filter strainer is
and spark are
sticky
The fuel is mixed
normal
with water
The engine is
overheating
Deposits on
exhaust
Overheating
The density of
of the engine
fuel is small
Deposits on
cylinder head
The oil is bad
The spark plug
Clean
is soot.
soot
The isolation
replace
of spark plug is
the spark
impaired
plug
poles are
replace
burned
the spark
plug
The isolation
of
replace or
cable is
correct
impaired
The isolation
Replace
of
the coil
coil is bad
The coil wire is
Replace
broken
the coil
Electronic
Replace
ignition device
device
is damaged
The intake
Reduce
of fuel is too
fuel
much
Inferior fuel
replace
mixed with
the fuel
water and dirt
Replace
Cylinders and
cylinder
rings are worn
and
or scored
segments
tighten
Spark plug is
the spark
loose
plug
No fuel in tank Load fuel
Filter strainer
Clean up
is dirty
The tank vent
Clean up
is blocked
Solution
Clean up
replace the fuel
Extinguish and
cool
Clean soot
Adjust the
carburetor
Clean soot
Use oil for this
purpose

Advertisement

Table of Contents
loading

Table of Contents