Raider RD-KMD02 User Manual page 15

tap and then stop the engine.
■ During the aerial spraying, put handles dust
and gas in the closed position. (Down position)
■ Upon conclusion of the work, close the gas
tap to prevent difficult lighting next time.
■ Note: While the engine is running, the hose
must be placed on the machine, otherwise, the
cooling air will be reduced and the engine may
be damaged.
I
Spraying / aerial spraying
1. Spraying.
Tighten the lid of the tank solution. Adjust
the aperture diameter of the nozzle to achieve a
variety of spray jets. Turn the tap to
Adjust the amount of spray solution. see
Figure 11
2. aerial spraying.
Adjust the release of chemicals by selecting the
switch position of the dust through the three holes
on the shoulder. see figure 12
fig.12
SAFETY AT WORK
Read the instructions carefully. Learn first
how to work with the machine before using it.
WARNING!
Wear clothes that are suitable for work.
■ Wear slip resistant footwear safety.
■ Wear gloves when handling.
■ Tie long hair over his shoulders.
■ Do not wear hanging clothes, ties, scarves
or ribbons.
Working with unsuitable clothing, can cause
accidents, slip, to be burned or getting caught in
the machine during operation.
When working, wear the following
protective equipment:
■ To protect the head, wear a
protective hat.
■ To protect eyes, wear safety
goggles.
■ To protect your ears, wear
headphones.
■ Wear knee pads.
If these precautions are not worn,
flying objects like rocks can cause
injuries.
- The machine can be used by:
■ mentally ill people.
■ drunken people.
■ minors or elderly people
■ People, uncomprehending of machines.
■ Tired or sick people and others use the
machine properly.
■ People who have trained harder or sleepy.
■ Nursing or pregnant women.
Prevention of fire
■ Do not burn or smoke near the machine.
■ Never refuel the machine while it is hot or
running.
■ Do not spill fuel on machine. If you do clear
it.
■ Always tighten the cap of the fuel tank.
■ Stay at least - least 10 feet from the tube
with fuel when you start the machine.
Start the machine (Figure 14)
■ If you plan to use the powder:
Place the handle in the dust - low position
before starting the engine, otherwise the chemical
will be disposed of while starting the engine.
■ It is forbidden to stand before sprayed tube
even when the valve is closed for dust because
it will be discarded and the remaining powder in
the tube.
See fig. 14
Spraying / aerial spraying
■ It is good to work in cool weather with little
wind. For example, early morning or late afternoon.
This will reduce evaporation and spreading of
chemicals and improve the protective effect.
15