Raider RD-GG05 User Manual page 22

22 www.raider.bg
to exceed the total power for AC and DC.
Most appliance motors require more than their rated wattage for start-up.
AC Applications
1. Start the engine and the multi monitor will display "0000".
2. Confirm that the appliance to be used is switched off, and plug in the appliance.
Substantial overloading that continuously lights the "FULL" of multi monitor may damage
the generator. Marginal overloading that temporarily lights the "FULL" of multi monitor may
shorten the service life of the generator.
Be sure that all appliances are in good working order before connecting them to the
generator. If an appliance begins to operate abnormally, becomes sluggish, or stops suddenly,
turn off the generator engine switch immediately.
3. In order to acquire both the best effect and the maximum service life of the generator.
Usually, the new generator should run 20 hours under 50% load, the generator may reach the
best performance.
Output & Overload
■In normal operating conditions, The multi monitor will display output of the generator.
■ If the generator is overloaded (in excess of Max. Output), or if there is a short in
the connected appliance, the multi monitor will display "FULL" and current to the connected
appliance will be shut off.
■ Stop the engine if the "FULL" of multi monitor and investigate the overload source.
■ Before connecting an appliance to the generator, check that it is in good order, and
that its electrical rating does
not exceed that of the generator. Then connect the power cord of the appliance, and start
the engine.
DC Application
The DC receptacle may be used for charging
12 volt automotive-type batteries only.
■ In DC operation, turn the Efficiency Mode switch to the ON position.
1. Connect the charging cables to the DC receptacle of the generator and then to the battery
terminals.
The zero load voltage is 15 V-30 V.