Table of Contents
Advertisement
Available languages
Available languages
PROBLEM
Appliance does not work.
Appliance cools too much. Temperature is set too cold.
The food is too warm.
Interior LED Light does not
work.
Heavy build-up of frost,
possibly also on the door
seal.
Unusual noises.
The compressor does not
start immediately after
changing the temperature
setting.
Water on the floor or stor-
age shelves.
POSSIBLE CAUSE(S)
Appliance is not switched on.
Mains plug is not plugged in or is
loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is not properly ad-
justed.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat
source.
LED Light is defective.
Door seal is not air-tight (possibly
after reversing the door).
Appliance is not level.
The appliance is touching the wall
or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
This is normal, no error has oc-
curred.
Water drain hole is blocked.
SOLUTION
Switch on the appliance.
Insert mains plug.
Check fuse,replace if necessary.
Mains malfunctions are to be corrected by an
electrician.
Turn the temperature regulator to a warmer
setting temporarily.
Please refer to the "Control panel" section.
Open the door only as long as necessary.
Turn the temperature regulation to a colder
setting temporarily.
Please look in the "Installing your new appli-
ance" section.
Please look in the "cleaning and care" sec-
tion.
Carefully warm the leaking sections of the
door seal with a hair dryer (on a cool setting).
At the same time shape the warmed door
seal by hand such that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the component
out of the way.
The compressor starts after a period of time.
See the "cleaning and care" section.
Advertisement
Table of Contents
