Scandomestic SKS 92 W User Manual page 30

6. Carefully lift the door and place it
on a padded surface to prevent
scratching.
7. Remove the plug (9) and transfer
it to the uncovered hole on the
right side of the unit. Be sure to
press the button firmly into the
hole. (Refrigerator without cover
panel)
8. Remove the two screws (1) that
hold the lower hinge (2) on the
right side of the unit.
9. Remove the screw-type leveling
front leg (4) and transfer it to the
right side as shown in the adja-
cent figure.
10. Set the door into it's new place
making sure the pin enters the
bushing at the lower frame sec-
tion (hole).
11. Secure the upper hinge (5) previ-
ously removed in step 6 on the
left side of the unit. Make sure
the pin enters the bushing on the
upper frame section (hole).
12. Loosely secure the lower left
hinge (2) and do not tighten the
bolts until the door is in the
closed position and leveled.
13. insert the plug (9) on the uncov-
ered holes (right side). (Refriger-
ator without cover panel)
14. Replace the upper hinge cap (7).
(Refrigerator
panel)
15. Turn the appliance upright again.
16. Mount the cover panel (11) at
the front and lay it flat on the
rear. (Refrigerator with cover
panel)
17. Apply the 2 screws (10) and
tighten. (Refrigerator with cover
without cover
panel)
18. Open the appliance doors and at-
tach all fittings.
1 Screws
2 Low Hinge
3 Adjustable Low
Foot
4 Adjustable High
Foot
5 Upper Hinge
6 Screw Bolt
7 Upper Hinge Cap
8 Shaft Sleeve
9 Plug
10 Scre
11 Cover panel