Brother 888-G60 Operation Manual page 57

Error messages
The authentication and encryption methods used by
the selected wireless LAN access point/router are
not supported by your machine.
15
The bobbin thread is almost empty.
16
The bobbin winder safety device has activated. Is the
17
thread tangled?
The carriage of the embroidery unit will move.
18
Keep your hands etc. away from the carriage.
The machine is still trying to connect to your wireless
19
network.
The safety device has been activated. Is the
20
thread tangled? Is the needle bent?
The SSID and Network Key are incorrect.
21
The wireless LAN access point/router cannot be
detected.
22
Cause/solution
The authentication/encryption methods used by the selected wireless access
point/router are not supported by your machine.
For infrastructure mode, change the authentication and encryption methods
of the wireless access point/router.
Your machine supports the following authentication methods:
Authentication method
WPA-Personal
WPA2-Personal
Open
Shared key
If your problem is not solved, the SSID or network settings you entered may
be incorrect. Reconfirm the wireless network settings. (page 14)
Refer to "How can I find the wireless security information (SSID and network
key)" on page 56.
This message is displayed when the bobbin thread is running out. Although a
few stitches can be embroidered when the "Start/Stop" button is pressed,
replace with a wound bobbin immediately.
When embroidering, press (Thread cutter button) to cut the threads, raise
the presser foot, remove the embroidery frame, and then replace the bobbin
with one wound with plenty of embroidery bobbin thread.
This message is displayed when the bobbin is being wound, and the motor
locks because the thread is tangled, etc.
This message appears before embroidery unit moves.
The machine is still trying to connect to your wireless network. Please wait a
few minutes, and then check the WLAN status.
This message is displayed when the motor locks due to tangled thread or for
other reasons related to thread delivery.
The security information (SSID/network key (password)) is incorrect.
Reconfirm the SSID and security information (network key (password)). (page
14)
Refer to "How can I find the wireless security information (SSID and network
key)" on page 56.
The wireless access point/router cannot be detected.
1. Check the following 4 points.
-
Make sure that the wireless access point/router is powered on.
-
Move your machine to an area where no items can obstruct the wireless
network signal, such as metal doors or walls, or closer to the wireless
access point/router.
-
Temporarily place your machine within about 1 m (3.3 feet) from the
wireless access point when you are configuring the wireless settings.
-
If your wireless access point/router is using MAC address filtering,
confirm the MAC address of this machine is allowed in the filter.
2. If you manually entered the SSID and security information (SSID/
authentication method/encryption method/network key (password)), the
information may be incorrect. Reconfirm the SSID and security information
and re-enter the correct information as necessary. (page 14) Refer to "How
can I find the wireless security information (SSID and network key)" on
page 56.
Troubleshooting
Encryption method
TKIP
AES
TKIP
AES
WEP
None (without encryption)
WEP
3
55