Table of Contents
Advertisement
INITIAL SETUP
This unit defaults to cable TV mode. When the unit is first powered on, it will detect the cable system
and auto-program the TV tuner to the available stations. Please wait while the unit auto-programs
before attempting to operate the unit. During this time the unit will not respond to any commands.
The unit will respond normally once the cable mode and channel search mode is concluded.
CHANNEL TUNING SETUP
If you are Cable TV subscriber, in addition to normal broadcast reception of VHF and UHF channels,
your new TV is capable of receiving many unscrambled Cable channels without the use of a converter
box. When set to broadcast (AIR) TV, it receives CH2-CH69. When set to one of the CATV modes
(STD, HRC, or IRC) it receives CH1-CH125. NOTE: Most cable companies broadcast in STD Mode
After a power interruption, the unit will go into a cable mode search (HRC, IRC, STD) and channel
search mode automatically. During this time the unit will not respond to any commands. The unit will
respond normally once the cable mode and channel search mode is concluded.
POSITIONING THE SCREEN
Press the screen lock button and pivot the screen forward until a comfortable viewing angle is reached.
The screen may also be rotated from side to side. Do not force the screen beyond its rotational limit.
The VE920 is now ready for use.
Pressing the ON/OFF button on the unit or the remote will turn the system on or off. Remember to turn
the unit off and pivot the screen to the closed position when not in use to prevent damage to the
screen.
SETTING THE TIME
NOTE: All settings (except setting the presets) are performed with the VE920 turned OFF.
1) Press the SET button and the minutes will flash.
2) Use the CH up/down button to set the minutes.
3) Press the SEEK button to toggle between the hour and minutes.
4) Use the CH up/down button to set the hour. (Check AM/PM indicator)
5) Press the ON/OFF button to return to the time display.
OPERATION
16
Advertisement
Table of Contents
