GE Security TruVision TVD Series Installation Sheet

GE
Security
TruVision Dome Installation Sheet
Description
The TruVision Dome is a high-resolution dome camera that that
can be used in retail, commercial, and residential environments.
The TruVision Dome uses a varifocal lens and offers custom
configurability.
Safety precautions
Read this installation sheet in its entirety before using the camera.
To avoid dangerous electrical shock or damage to the equipment,
do not try to disassemble the camera or any of its components.
Do not attempt to service this camera by yourself unless you are
authorized to do so. Opening the cover may expose you to
dangerous electrical shock or other hazards. Only a service
technician should perform this procedure.
Never point the camera at the sun and do not expose the lens
directly to the sun or strong light as this may damage the camera.
Handle the camera with care. The camera contains sensitive
components, avoid any shock or impact to the camera. Improper
handling can damage the camera.
The camera is designed for indoor use. Do not use the camera
when the temperature is lower than −10°C (14°F) or higher than
+50°C (122°F). For safe camera usage, the maximum humidity
should not exceed 85%. If the camera is placed in an extremely
dusty location, special housing may be needed to protect the
camera and lens.
Installation
Before installing the TruVision Dome, make sure that the location
is mechanically sound, protects the camera, and affords the
required views. Once the camera is securely mounted, follow the
procedure below to connect the camera. For power and video
connections see Figure 1 below. For camera dimensions see
Figure 2 and Figure 3 on page 2.
All manuals and user guides at all-guides.com
© 2009 GE Security, Inc.
Figure 1: TruVision Dome camera power and video connections
To install the camera:
1. Fasten the camera to a wall or ceiling (or another solid
surface). The camera must be stable when connected.
2. Connect the 75 Ω coaxial cable to the video output.
3. Connect the power cable to the camera.
4. Adjust the camera position and angle as required.
Camera dimensions
Figure 2: TruVision Dome dimensions - base attachment
1 of 2
P/N 1069136 • REV 1.0 • ISS 27OCT09