Inspect Exhaust System; Inspect/Test Fuel Supply System; Repair Parts; How To Order Parts - Generac Power Systems 006071-0 Owner's Manual

7. Finally, install and tighten the oil vent cap and oil level check
plug.
8. Re-install negative battery cable and panel fuse. Start unit and
check for leaks.
Figure 4.1 – Gearbox Oil Servicing Points

INSPECT EXHAUST SYSTEM

Every three months (or 120 hours), an authorized operator should
inspect the entire exhaust system. Abnormal noise levels heard
during each operational test may indicate a defective exhaust pipe
or muffler. Any defective or leaking component should be repaired
or replaced immediately by an Authorized Service Technician.

INSPECT/TEST FUEL SUPPLY SYSTEM

Every three months (or 120 hours), an authorized operator should
inspect and test the fuel supply system, as well as all fuel system
connections. All connections must be tight and in good condition.
A loose fuel system line may show no signs of leakage, but may
draw air into the system causing rough operation and starting dif-
ficulties. Any defective or leaking component should be repaired or
replaced immediately by an Authorized Service Technician.
VENT CAP
OIL FILL/LEVEL
CHECK PLUG

REPAIR PARTS

The latter portion of this manual consist of exploded views,
parts lists and electrical data pertaining to this generator set. The
parts lists consist of (a) an item number, (b) a part number, (c)
the quantity required, and (d) a description of the part. The item
number corresponds to an identical number on the exploded view
drawing.

HOW TO ORDER PARTS

To order a replacement part, locate the part in the applicable
exploded view. Contact an Authorized Service Dealer (call 800-
333-1322 to locate one in the area) and provide the following
information:
• The generator model number.
• The generator identification code, which indicates the specific
generator assembly for each unit.
• The part number and corresponding description from the appli-
cable parts list in this manual.
• The applicable exploded view "Group" letter (A-H) and draw-
ing number (five-digit number), which can be found on the
exploded view drawing.
In most cases, repair parts can be obtained by providing the
Authorized Service Dealer with the data label information and
a description of the required part. If unable to locate either
the data label or the construction document, describe the part
needed and provide the unit's model number. This number can
be found on the DATA LABEL attached to the generator's lower
connection box.
Maintenance
NOTE:
15