Advertisement
Regular Maintenance
For great-tasting coffee, keep your coffee maker running at peak performance by following the
recommended maintenance schedule:
Frequency
Every 2 months
Every 3 months or when
the Descale notification
turns on*
*To turn off Descale notification, follow the full descaling procedure as outlined in this guide.
If the coffee maker has been in storage, or hasn't been used in days, run a cleansing brew before brewing
your beverage.
Periodically hand-wash the water reservoir and lid and drip tray with warm soapy water and rinse clean.
CAUTION: Parts are not dishwasher safe.
NOTE: Do not dry the inside of the water reservoir with a cloth as lint may remain.
K-Cup® Pod Holder
To remove the K-Cup® pod holder from
the coffee maker, lift the handle and
grasp the top of the K-Cup® pod holder
with one hand while pushing up on
the bottom of the K-Cup® pod holder
from underneath with the other until
STR ONG
it releases. After cleaning, align the
K-Cup® pod holder with the opening
using the two front ribs as a guide
and snap into place from the top.
CAUTION: There are sharp needles that puncture the recyclable* K-Cup® pod above the K-Cup® pod
holder and in the bottom of the K-Cup® pod holder. To avoid risk of injury, do not put your fingers in the
K-Cup® pod holder.
NOTE: Always remove and recycle the used recyclable* K-Cup® pod after brewing.
Funnel
Washing the funnel ensures a fresh
beverage experience. The funnel
should be washed regularly and can
be removed from the K-Cup® pod
holder by pulling on it until it pops off.
To replace it, orient the snaps to the
indent and just snap it back onto the
K-Cup® pod holder.
*Recyclable in select locations.
Visit keurig.ca/recyclable for more information.
Product
Keurig ® Water Filters
Keurig ® Descaling Solution
Benefit
Keeps your water fresh and help remove impuri-
ties
Eliminates mineral buildup to preserve the long-
term health of your coffee maker
Exit Needle
Remove the pod holder assembly
and detach the funnel. Locate the
exit needle on the inside bottom
of the K-Cup® pod holder. Insert a
straightened paper clip into the exit
needle to loosen any coffee grounds.
Entrance Needle
Lift the coffee maker handle and
locate the entrance needle on the
underside of the lid. To clean the
holes in the needle, hold the coffee
maker handle in the upward position
and with your other hand, carefully
insert a straightened paper clip into
all the holes. Gently move it around
to loosen any coffee grounds. Lower
the handle completely and run a
cleansing brew two times. Do not
insert a recyclable* K-Cup® pod.
Advertisement
