OrienTek T15M Instruction Manual

T15M small stable light source instruction manual
Products introduction
T15M stable light source, which is characterized by output
optical power, wavelength and spectrum.The width is stable
and the range of change is small. While the appearance is
upgraded, LED lighting is added.Provide 1310nm and 1550nm
dual-wavelength laser output, mainly used for FTTX
network.And fiber optic testing. When combined with an
optical power meter, it is used to measure optical power and
end End-to-end optical loss.
8
3
9
4
5
7
1
OLS interface:
9
2
LED lighting
3 11
Display
4
Enter key 8
5
LED key 10
6
CW/HZ key 12
Power-on and power-saving function settings
Auto-off
The equipment will turn on
after pressing the " " key. Press
this button again for more than
two seconds to shut down.
This instrument has power saving
function, normal there is no operation
for about ten minutes after booting,
The device will automatically shut down.
If you needa screen Shield this function
to keep the equipment working all the
time Status, just short press "on" when
booting Key, "Auto-off" at the bottom
left of the meter display. Disappearing
means that the power saving function
is cancelled.
1
2
10
270
HZ
11
1310
nm
12
Auto-o
6
CW/HZ
7
KLS-25m Light Source
On/off key: turn on or off the device
Automatic shutdown
Unit
Power supply battery
Frequency
Wavelength
270
HZ
1310
nm
Auto-off
CW/HZ
Backlight control
In the power-on state, the backlight
will automatically turn off after a
period of time. After turning off, press
any key to activate the backlight. The
backlight is used to illuminate the
instrument display at night or in dark
270
HZ
places.
1310
nm
Auto-o
CW/HZ
Wavelength selection
1310
nm
1550 nm
According to the needs of the project,
select the corresponding wavelength to
match the optical power meter. After the
meter is turned on, press the "output
wavelength" key, the output wavelength
and length will be switched to the
corresponding wavelength in turn, and
will be displayed on the display. The
laser light source of this series can
provide 1310nm and 1550nm
dual-wavelength laser output according
to demand.
λ
Carrier output
In the actual project, it is necessary to
load the audio carrier in the optical signal
270
HZ
to identify the optical fiber. The equip-
1310
nm
ment contains three carrier frequencies,
which are 270Hz, 1KHZ, and 2KHz. After
Auto-o
pressing the "modulated carrier" key, the
equipment will load different carriers in
sequence, and the display will be
displayed at the same time. The current
CW/HZ
carrier frequency will be displayed on the
screen.
CW/HZ
270
HZ
1310
nm
Auto-o
CW/HZ
KLS-25m Light Source
270 1000
HZ HZ
2000
HZ
CW/HZ