OrienTek T11P Instructions For Use

T11P Visual Fault Locator Instructions for use
Products introduction
This product uses a 650nm semiconductor laser as a light-
emitting device and is driven by a constant current source
to emit stable red light; it enters a single-mode or multi-
mode fiber after being connected to an optical fiber
interface to realize the function of fiber fault detection. It
is a fiber optic engineering construction and a fiber optic
network. An indispensable tool for maintenance, optical
device production and research.
Ceramic ferrule
Pilot lamp
Product features
650nm red laser.
Pulse and continuous wave operation.
Output power: 1MW, 10MW, 20MW, 30mw.
2.5 Universal connector.
30 hours operation (1MW).
1.25mm LC adapter (optional).
Metal Material.
Find fiber microbends, breaks and fiber damage.
Silicone cap
Power on/off button
the optical fiber interface under test
into the laser connector.
On/off button
Long press "
light will light up, and the laser will output continuous
wave at the same time;(If the fiber is connected, red
light can be seen at the end of the fiber under normal
circumstances; if the tested fiber is disconnected,
there is no red light output at the end of the fiber).
Shortly press the power button, the indicator
light flashes, and the laser pulse wave is output at
the same time; short press again to turn off the red
light.
Under normal circumstances, it will automatically
shut down if there is no operation for 15 minutes to
extend the battery life.
Laser connector
Open the dust cap and insert
"to turn on, the red indicator