Advertisement
Quick Links
PRODUCT NAME: Devon Rechargeable LED Table Lamp
ITEM NUMBER: LA245
ASSEMBLED DIMENSIONS: 20 1/2"H x 8 1/8"W x 8 1/8"D
IMPORTANT SAFETY INSTRUCTIONS:
- For your safety, please read instructions carefully and completely before beginning assembly
or installation.
- Do not remove screws, open Lamp or remove/replace battery. Battery is not replaceable.
- This Lamp features an integrated 2 Watt/12v DC/G4 LED Disc.
- Charger/Adapter must be plugged into a standard (110v) indoor grounded wall outlet.
- Charger/Adapter for exclusive use with this Lamp. Do not use for other purposes.
- When not in use, unplug Charger/Adapter from both wall outlet and Lamp.
WARNING:
- Deviation from assembly instructions may cause risk of fire or electric shock.
- Do not expose Lamp to water. Use and charge in a dry environment. Not weatherproof.
- Do not touch or look directly at illuminated LEDs.
- Do not tamper with nor puncture battery.
- Designed for use at temperatures between 32 to 100 degrees Farenheit.
- Protect Lamp from direct heat sources.
- Do not dispose battery trash. Refer to local regulations for proper disposal.
- Battery should be fully discharged before disposal at a Battery Recycling Center.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
MADE IN CHINA
Page 1 of 4
Advertisement
Related Manuals for Ballard Designs LA245
Summary of Contents for Ballard Designs LA245
- Page 1 Customer Service: 800-367-2810 Online: www.ballarddesigns.com PRODUCT NAME: Devon Rechargeable LED Table Lamp ITEM NUMBER: LA245 ASSEMBLED DIMENSIONS: 20 1/2”H x 8 1/8”W x 8 1/8”D IMPORTANT SAFETY INSTRUCTIONS: - For your safety, please read instructions carefully and completely before beginning assembly or installation.
- Page 2 Remove all parts, hardware and protective packaging from carton and carefully arrange on a clean, level surface. NOTE: To avoid accidentally discarding small parts or hardware, retain all carton contents until after assembly and installation are complete. Recommended Location for Use: Dry Indoor Environment PARTS Check to make sure you have the following: INCLUDED:...
- Page 3 STEP 1: ATTACH HARP Gently raise Caps (E) on each side of Harp (D) Saddle and while squeezing ends together, fit harp into Saddle then lower Caps to secure. STEP 2: FIT AND ATTACH SHADE Remove Finial (A) from Harp (C) then gently lower Shade (B) onto top of Harp.
- Page 4 STEP 3: CHARGING Insert the small plug into the port on the back of lamp base. Plug Charger/Adapter into a standard indoor wall outlet. NOTE: Charger will illuminate a solid RED light to indicate active charging. A solid GREEN light will illuminate to indicate charging is complete.