Advertisement
Feed power cable through Printer
6
Mount and plug into Printer
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
T20 Pin Torx Driver Bit
M4x20mm Button head screw
Case Washer
Locate and secure the Case onto the
9
Mounting Arm as shown. Tighten by
hand.
4x Corner Pieces
4x Tablet Supports
1x Cable Clip
Install the Tablet Setup Kit. Each kit is
12
specific per device & case.
7
Re-attach Neck-Ring
M4 Split Washer
Unlock & remove the Faceplate from
10
the Bouncepad Case.
Install the tablet into the Case &
13
connect to power.
Pull cable back to remove any slack
8
near the Printer Mount
Feed the tablet power cable through
11
the Case & Floorstanding Pole.
Locate and lock the Faceplate to the
14
Case.
Advertisement
