Channel Tuning Setup - ASA Electronics LCM1042TV Owner's Manual

CHANNEL TUNING SETUP

In order to easily access all available channels, it may
be necessary to perform channel auto - programming
whenever the vehicle's geographic location has
changed, i.e. city to city, weak signal area.
1. Press the AUTO MEMORY button on the remote
control unit. You will see the TV cycle through all
it's channels. The built-in microprocessor will
automatically store each channel that is actively
broadcasting in your area.
2. (A) To tune only stored clear channels with the
CHANNEL UP/DOWN
SKIP/SEARCH button on the Remote Control Unit
until "SKIP MODE ON" is displayed on the bottom
of the screen. The TV will now tune only to stored
channels when the CHANNEL UP/DOWN buttons
are used on the monitor or the remote control. (B)
To tune to weak or marginal channels with the
CHANNEL UP/DOWN
SKIP/SEARCH button on the Remote Control Unit
until "SKIP MODE OFF" is displayed on the bottom
of the screen. Tune to the desired channel using
the CHANNEL UP/DOWN buttons or go directly to
the channel by using the 0-9 buttons on the
Remote Control.
buttons, press the
buttons, press the
3. To ERASE a channel, press the ERASE/ WRITE
button on the Remote Control Unit until "MANUAL
MEMORY XX ERASE " is displayed on screen.
To STORE a channel, press the button until the
MANUAL MEMORY XX ADD is displayed on
screen.
Note: Please refer to page 2 for more information on
TV reception.
TURNING THE LCM1042TV ON OR OFF
1. Sliding the screen release lock forward will unlock
the LCD screen and it will drop down slightly. (Pivot
the screen downward until a comfortable angle is
reached).
2. Pressing the power button on the pod or remote will
alternately turn the system on or off. When in use
the internal back lighting will illuminate the controls.
After the unit has been turned on and is displaying
a picture, adjustment to the viewing angle can be
made by pivoting the screen to optimize the picture
quality. The friction hinges will hold the screen in
position while the system is in use.
3. Remember to turn the unit off and pivot the LCD to
the locked position when not in use.
-9-