Advertisement
Quick Links
ASA Electronics TV/VCP Floor Console
Model K-13 Without Harness and Antenna
12 Volt DC powered remote controlled 13" television AVT-1475
12 Volt DC powered remote controlled VHS Video Cassette Player AVP-7000
Installation Instructions
Audiovox Specialized Applications, LLC.
"The Mobile Electronics Company"
23319 Cooper Drive
Elkhart IN 46514
1 (219) 264-3135
www.audiovox.com
Page1 of 10
P/N 8007131
Rev. C 1/12/99 BJ
Advertisement
Related Manuals for ASA Electronics K-13
Summary of Contents for ASA Electronics K-13
- Page 1 ASA Electronics TV/VCP Floor Console Model K-13 Without Harness and Antenna 12 Volt DC powered remote controlled 13” television AVT-1475 12 Volt DC powered remote controlled VHS Video Cassette Player AVP-7000 Installation Instructions Audiovox Specialized Applications, LLC. “The Mobile Electronics Company”...
- Page 2 This manual contains specific instructions on how to install this automotive TV/VCP floor console. Please read this manual thoroughly before installing the console into the vehicle. In order to maintain a safe mounting system, this console MUST be secured to the floor of the vehicle according to the instructions contained in this manual.
- Page 3 There are six (6) steps to install the K-13 TV/VCP floor console: Step # 1 Disassemble shroud Step # 2 Install brackets and straps Step # 3 Mount the console on the floor of the vehicle Step # 4 Install the VCP...
- Page 4 Step #2) Install brackets and straps 1) Mount brackets, using only four screws. Do not use center hole. 2) Use soldering iron, if necessary, to melt holes in open strap and loop strap, as shown. Page4 of 10 P/N 8007131 Rev.
- Page 5 3) Pre-drill pilot holes on side of VCP shelf (A) and on bottom of TV shelf (B) using 1/8” drill bit. Page5 of 10 P/N 8007131 Rev. C 1/12/99 BJ...
- Page 6 4) Attach both straps, use TV and VCP to help locate strap if necessary. Page6 of 10 P/N 8007131 Rev. C 1/12/99 BJ...
- Page 7 Step 3) Install console to floor of vehicle. BEFORE DRILLING ANY HOLES VERIFY THAT THE DRILL BIT WILL NOT ENTER INTO THE FRAME RAIL(S) OF THE VEHICLE, ELECTRICAL WIRES, FUEL LINES, BRAKE LINES, HOSES, EXHAUST SYSTEMS OR ANY OTHER ITEMS THAT WILL IMPAIR THE OPERATION OF THE VEHICLE. THE BOLTS OF THE FLOOR CONSOLE MUST SECURE TO THE FLOOR PANEL OF THE VEHICLE.
- Page 8 Step 4) Install the VCP into the console. Remove the VCP from the box. Connect the white RCA connector (customer supplied) from the console to the white audio output of the VCP Connect the yellow RCA connector (customer supplied) from the console to the yellow audio output of the VCP Connect the DC power connector (customer supplied) to the DC power jack of the VCP.
- Page 9 Step 5) Install the TV into the console. Connect the yellow RCA patch cord (customer supplied) to the yellow RCA video input jack on the rear of the television Connect the white RCA patch cord (customer supplied) to the white RCA audio input on the rear of the television Connect the DC power connector (customer supplied) to the rear of the television...
- Page 10 Step 6) Replace the rear shroud and face of console. Place the rear and face of the console over the body of the console. Gently tap into place. Reinstall the four Phillips screws that held the face to the body. Page10 of 10 P/N 8007131 Rev.