Eaton ALLEPSD2430 Installation Sheet

Installation sheet
Service pullout
Item numbers Item numbers
ITEM NUMBERS
ALLEPSD2430 (1) 7/16" Socket wrench (not supplied)
ALLEPSD2430
ALLEPSD3030
ALLEPSD3030 (1) 3/8" Socket wrench (not supplied)
ALPEPSD2430
ALPEPSD2430 (1) 5/32" Allen wrench (supplied)
ALPEPSD3030
ALPEPSD3030 (1) Level (not supplied)
TOOLS REQUIRED
(1) Rubber mallet
(1) 7/16" Socket wrench (not supplied)
(1) 3/8" Socket wrench (not supplied)
(1) 5/32" Allen wrench (supplied)
(1) Level (not supplied)
IMPORTANT! The LMS Full Frame must be
(1) Rubber mallet
level before installing the Service Pullout.
IMPORTANT! The LMS Full Frame must be level
before installing the Service Pullout.
Positioning the service pullout
POSITIONING THE SERVICE PULLOUT
The Service Pullout can be installed at four The Service Pullout can be installed at four different
heights at one inch increments. The minimum height is
different heights at one inch increments.
34", the maximum height is 43". See figure 1.
The minimum height is 34" , the maximum
height is 43" . See figure 1.
1. Determine the desired height of the
Service Pullout and then insert the hooks*
on the back of the unit into the slotted
standards and push down. See figure 2a. To
ensure that the hooks are seated, tap the
1. Determine the desired height of the Service Pullout
top rear corners with a rubber mallet.
and then insert the hooks* on the back of the unit into
the slotted standards and push down. See figure 2a.
To ensure that the hooks are seated, tap the top rear
corners with a rubber mallet.
*NOTE: It is suggested that the hooks be
bent out slightly to ease insertion into the
*NOTE: It is suggested that the hooks be bent out
slightly to ease insertion into the slotted standards.
slotted standards. See figure 2b.
See figure 2b.
91712
S e r v i c e
I n s t a l l a t i o n
Hook
Hook
Bend out slightly
Bend out slightly
Figure 2a
Figure 2a
Rev. __ Date:
P u l l o u t
Service pullout
Service Pullout
43" Maximum
43" Maximum
34" Minimum
34" Minimum
Figure 1
Figure 1
Hook plates
Hook Plates
Hooks
Hooks
Figure 2a
Figure 2a
1
LMS Full frame
LMS Full Frame
Service pullout
Service Pullout
Slotted standards
Slotted standards