Advertisement
Disassembly method
Removing the top cover
1.
Remove the four screws A attaching the top cover
on both sides of the body.
2.
Remove the three screws B on the back of the body.
3.
Remove the top cover from behind in the direction of
the arrow while pulling both sides outward.
Removing the front panel assembly
Prior to performing the following procedure, remove
the top cover.
1.
Disconnect the card wire from connector CN402 on
the audio board and CN201 on the power supply
board in the front panel assembly.
2.
Cut off the tie band fixing the harness.
3.
Remove the three screws C attaching the front panel
assembly.
4.
Remove the four screws D attaching the front panel
assembly on the bottom of the body. Detach the front
panel assembly toward the front.
Removing the voltage selector
Prior to performing the following procedure, remove
the top cover.
1.
Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
2.
Remove the two screws E' attaching the rear panel
on the back of the body.
Removing the rear panel
Prior to performing the following procedure, remove
the top cover.
1.
Remove the power cord stopper from the rear panel
by moving it in the direction of the arrow.
2.
Remove the twenty eight screws E attaching the
each boards to the rear panel on the back of the
body.
3.
Remove the four screws F attaching the rear panel
on the back of the body.
All manuals and user guides at all-guides.com
(See Fig.1)
(See Fig.2 and 3)
(See Fig.4)
(See Fig.4)
Top cover
A
2
A
2
C
Tie band
Main
board
CN402
Audio board
Fig.2
D
Fig.3
E
E
E
E
E
Rear panel
F
Fig.4
RX-7012VSL
B
Fig.1
Front panel assembly
C
CN201
Power supply
board
Front panel assembly
D
Cord stopper
E
E'
F
F
F
E
1-3
Advertisement
