Trouble
The stopped watch was
exposed to adequate light
for a longer time than "the
Charging
time required for fully
the watch
charging the watch,"
however, it does not resume
its normal one-second
interval movements.
Button
Buttons or crown
operation
cannot be operated.
Display
Nothing is displayed.
Blur on the dial glass
Others
persists.
※For the solutions of troubles other than the above, contact the retailer from whom the watch was purchased or the SEIKO CUSTOMER SERVICE CENTER.
Possible Cause
The light is too weak or the manner
of lighting the watch has been
altered while the watch is being
charged.
The built-in IC has fallen into an
unstable condition.
The energy stored in the watch runs
low.
Small amount of water has got
inside the watch due to deterioration
of the gasket, etc.
Place the watch where it can be exposed to an adequate light source. Make sure that the manner of
lighting the watch is not altered while the watch is being charged.
Reset the built-in IC. For details, refer to "How to Reset the Built-in IC" on P. 74.
Refer to "Display and Remaining Battery Amount" on P. 50 to charge the watch.
Contact the retailer from whom the watch was purchased.
Solution
73