Serial Number………….. YOUR ATTACHMENT DEALER ADDRESS: PHONE: CONTACT: NOTE: Erskine Attachments LLC reserves the right to make improvements in design or changes in specifications at any time without notice and without incurring any obligations to install them on units previously sold.
Indicates potentially Erskine Attachments LLC cannot anticipate every hazardous situation which, if not avoided, possible circumstance that might involve potential will result in death or serious injury. hazard. The safety messages found in this manual ...
Page 4
Do not modify equipment or add attachments that Use a piece of paper or cardboard, NOT BODY are not approved by Erskine Attachments LLC. PARTS, to check for suspected leaks. Wear protective gloves and safety glasses or goggles...
SERIAL NUMBER AND SAFETY DECAL LOCATIONS Serial Number Location: It is important to refer to the serial number of your attachment when making repairs or ordering parts. Early or later models (identification made by serial number) may use different parts, or it may be necessary to use different procedures in doing a specific operation.
Page 6
On each side of mount plate support near step Quantity: Safety Decals Locations: The locations of the safety decals are shown. If these decals are missing, damaged, or painted over they must be replaced. Call Erskine Attachments LLC (218-435-4045) for replacement decals.
USER’S MOUNTING INSTRUCTIONS After the initial set-up assembly is completed use the following procedure to mount the attachment to the loader for user operation. Coupler wedges or pins must extend through the holes in attachment. Levers must be fully down and locked. Failure to secure wedges or pins can allow attachment to come off and cause injury or death.
Page 8
USER’S MOUNTING INSTRUCTIONS 7. Connect the hydraulic quick couplers from the attachment to the loader. IMPORTANT: Make sure quick couplers are fully engaged. If the quick couplers do not fully engage, check to see that the couplers are the same size and brand.
OPERATING INSTRUCTIONS________________ To avoid tipping, NEVER exceed maximum load. ALWAYS know load weight before lifting. Maximum load depends on configuration: Rated load of attachment: Full retraction: 750 lbs. Cylinder extended only: 650 lbs. Full extension: 350 lbs. 1.
PARTS INFORMATION REF. PART NO. DESCRIPTION 2ND DESCRIPTION QTY. 314301 MOUNT TUBE 314302 MIDDLE TUBE 314303 INNER TUBE 316026 PIN 1 X 5 314327 CYLINDER 2.50 X 72 TIE ROD RED OR BLACK 314326 TUBE CYLINDER KEEPER 300231 ADPT STR 6MP-6MJ IF RED CYLINDER 201925 ADPT STR 8MB-6MJ...
Erskine Attachments, LLC to improve its products whenever it is possible and practical to do so. Erskine Attachments, LLC reserves the right to make changes and or add improvements at any time without incurring any obligation to make such changes or add such improvements to products previously sold.
Page 16
P/N 314349 Date Printed: 9/18/2018 Printed in U.S.A. Erskine Attachments LLC...
Need help?
Do you have a question about the HB 18 and is the answer not in the manual?
Questions and answers