Install The Header; Set The Header Height - Kohler BodySpa K-1015 Installation Manual

1/4" Washer
1/4-20 x 5/8"
Buttonhead
Screw
Header
Bracket

14. Install the Header

With assistance, lift the header between the center supports so the bottom side holes in the header
brackets fit over the adjustment screws.
Check the alignment of the side holes in both header brackets to the adjustment screw heads. If the
holes do not line up, loosen the setscrews in the header bracket(s), and realign the header bracket(s)
until the holes align with the adjustment screw heads. Retighten the header bracket setscrews.
Add a 1/4" flat washer to each of the two buttonhead screws. Thread a buttonhead screw and
washer through each header bracket top hole, and into the center support.
Securely tighten each buttonhead screw with the supplied hex tool and ratchet wrench.

15. Set the Header Height

Measure the distance between the header height and the footbath rim at both the end and the center
of the header. Compare the distance. The header should be 1/4" (6 mm) higher at the center. The
combined weight of the door panels will pull the header down until it is level or close to level.
Adjust the level of the header by first loosening the buttonhead screw securing the header to the
center support. Back out the adjustment screw one or two turns. Retighten the buttonhead screw
with the hex tool and ratchet. This will cause the header to pivot slightly upward.
Alternate this procedure on both ends of the header and remeasure the header height at both ends
and the center. Tighten the buttonhead screws when the adjustments are complete.
IMPORTANT! The header must be 1/4" (6 mm) higher at the center. The center of the header must not
sag downward or the door panels will not operate correctly.
1032118-2-D
Header
Setscrew
Adjustment
Screw
Center Support
End
Tape
Measure
14
Center
Kohler Co.