Table of Contents
Advertisement
Available languages
Available languages
TROUBLESHOOTING:
Symptom
Light will not turn on.
Fuse blows or circuit breaker
trips when light is turned on.
PRODUCT MAINTENANCE:
1.
To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use
clean water, never a solvent) to wipe the glass and surface of the fixture.
2.
To clean the inside of the fixture, first disconnect power to the fixture by turning off
the circuit breaker or by removing the fuse at the fuse box. Next, use a dry or slightly
dampened clean cloth (use clean water, never a solvent) to wipe the inside glass and
interior surface of the fixture.
3.
Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry
soft cloth to dust or wipe carefully.
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a
period of three (3) years from date of purchase. This warranty applies only to the original consumer
purchaser and only to products used in normal use and service. If this product is found to be defective, the
manufacturer's only obligation, and your exclusive remedy, is the repair or replacement for the product at
the manufacturer's discretion, provided that the product ahs not been damaged through misuse, abuse,
accident, modifications, alterations, neglect, or mishandling. This warranty shall not apply to any product
that is found to have been improperly installed, set-up, or used in any way not in accordance with the
instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of
an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to
faculty material or workmanship. This warranty shall not apply to the finish on any portion of the product,
such as surface and/or weathering, as this is considered normal wear and tear.
The manufacturer does not warrant and specially disclaims any warranty, whether express or implied
of fitness for a particular purpose, other than the warranty contained herein. The manufacture
specifically disclaims any liability and shall not be liable for any consequential or incidental loss or
damage, including but not limited to any labor/expense cost involved in the replacement or repair of
said product.
Possible Cause
1. Power is off.
2. Faulty switch.
3. Faulty wire connection.
1. Crossed wires or power wire is grounding
out.
LIMITED WARRANTY
Corrective Action
1. M ake sure power supply is on.
2. Test or replace switch.
3. Check wiring.
1. Check wire connections.
Page 8
Advertisement
Table of Contents
