Advertisement
Operation
Operation
1
Turning the light on
Turn the light switch on to activate the fixture.
If it is daylight, the fixture will not illuminate. To test the
fixture, cover the photocell with electrical tape. Once you
confirm the fixture illuminates, remove the electrical tape.
If it is daylight, the fixture may not illuminate with the
electrical tape over the photocell, as the photocell can be
sensitive. Wait until nighttime to confirm the fixture
illuminates.
Care and Cleaning
Care and Cleaning
Clean the lamp with a soft, dry cloth.
Do not use any cleaners with chemicals, solvents, or harsh abrasives.
Troubleshooting
Troubleshooting
Problem
The bulb will not light.
The fuse blows or circuit
breaker trips when the
light is turned on.
Possible Cause
The power is off.
There is a faulty wire connection.
The circuit breaker is off.
There are crossed wires or the
power wire is grounding out.
Solution
Ensure the power supply is On.
Check the wiring.
Ensure the circuit breaker is in the On position.
Check the wire connections.
Contact a qualified electrician or call the Customer Service Team at
1-800-986-3460.
6
Advertisement
