Samsung DVD-V5450 Service Manual page 55

Operating Instructions
Connecting DVD-VCR to
the TV using the Coaxial
Cable
To receive television programmes a signal must be
received from one of the following sources:
• An outdoor aerial
• An indoor aerial
• A cable television network
• A satellite receiver
Make sure that both the television and the
DVD-VCR are switched off before connecting
Note
the cables.
1 Remove the aerial or network input cable from
the television.
2
Connect this cable to the 75Ω coaxial socket
marked on the rear of your DVD-VCR.
3 Plug the coaxial cable supplied into
the socket on your DVD-VCR.
4 Plug the other end of the coaxial cable into
the connector previously used for the aerial
on the television.
TV
4
RF cable
12-6
TV
Aerial
2
3
Connecting DVD-VCR
to the TV using the
SCART Cable
You can connect your DVD-VCR to the television
using the SCART cable if the appropriate input is
available on the television. You thus:
• Obtain better quality sound and pictures
• Simplify the setting up procedure of your DVD-VCR
Regardless of the type of connection chosen,
you must always connect the coaxial cable
Note
supplied. Otherwise, no picture will be visible on
the screen when the DVD-VCR is switched off.
Make sure that both the television and the
DVD-VCR are switched off before connecting
the cables.
1 Connect the coaxial cable.
2 Connect one end of the SCART cable to the
AV1 (EURO AV) socket on the rear of the
DVD-VCR.
3 Plug the other end into the appropriate
connector on the television.
Connecting the Audio Output Cable
You can connect your DVD-VCR to a Hi-Fi system.
Example:You wish to take advantage of the quality of
your Hi-Fi stereo system when watching a
programme or recording via your DVD-VCR.
4 Plug the audio output cable into the audio
connectors on the rear of your DVD-VCR.
5
Plug the other end of the audio cable into the
appropriate input connectors on your Hi-Fi
stereo system.
Aerial
TV
3
RF cable
4
4
2
English - 11
Samsung Electronics