Table of Contents
Advertisement
xCORE-Analog sliceKIT Hardware Manual
PCIE A (BOT)
A1
A2
A3
A4
A5
A6
A7
A8
A9
A10
A11
KEY
A12
A13
A14
A15
A16
A17
A18
2.10.7 System Services Slot Signals
On all Slots, TDO is always out of the sliceKIT Core Board, TDI is always in to the
Core Board.
MSEL, TCK, TMS, RST_N are all inputs to the Core Board from the Chain Connector
and outputs from the Core Board on the Square Slot.
DEBUG is bidirectional.
PRSNT is used on the Chain Connector to detect it is plugged into the Square Slot
of another Core Board. This signal is used to switch JTAG and CLK sources.
Similarly, PRSNT_N is used on the Star Slot to detect another Core Board is
connected. This signal is used to switch the JTAG chain signals.
CLK and RST_N are inputs to the Core Board from the Chain Connector and output
from all Slots.
XM005221A
SIGNAL
FUNCTION
NC
NOT CONNECTED
5V
POWER SUPPLY 5V
X0D13
P1F0
WAKE
SYSTEM WAKE SIGNAL (X0D43)
GND
POWER SUPPLY GROUND
ADC4
ADC CHANNEL 4
ADC5
ADC CHANNEL 5
GND
POWER SUPPLY GROUND
ADC6
ADC CHANNEL 6
GND
POWER SUPPLY GROUND
GND
POWER SUPPLY GROUND
KEY
MECHANICAL KEY
NC
NOT CONNECTED
NC
NOT CONNECTED
GND
POWER SUPPLY GROUND
NC
NOT CONNECTED
RST_N
SYSTEM RESET (ACTIVE LOW)
ADC7
ADC CHANNEL 7
GND
POWER SUPPLY GROUND
25/33
Advertisement
Table of Contents
