Table of Contents
Advertisement
V-026 Series User Guide.qxd:V-026
vax.co.uk
4. Operation
IMPORTANT: Turn off when emptying and filling
!
the clean water tank.
Filling the clean water tank
Remove clean water tank from the carpet washer
(Fig.4/1).
1
2
Fig.4/1
Unscrew the filler/measure cap from the rear of the clean
water tank. Fill the bottle cap or measure cap 3 times with
Vax carpet cleaning solution and pour into the tank
(Fig.4/2).
Fig.4/2
Fill the remainder of the clean water tank with warm (max
40°C) tap water. Replace the cap (Fig.4/3).
Fig.4/3
6
operation
26/3/10
15:45
All manuals and user guides at all-guides.com
Page 6
NOTE: Use only Vax carpet cleaning solution, as other
cleaning solutions may cause excessive foaming. This may
cause the float to shut off the cleaner prematurely. Using
other cleaning solutions will invalidate your guarantee.
Place the bottom of the clean water tank into the cleaner
and push into place. There will be an audible click when the
clean water tank is in the correct position.
Operating the carpet washer
IMPORTANT: Never leave the cleaner unattended
!
with the power on. Vacuum carpets thoroughly
with dry vacuum cleaner before washing.
Plug the cord into a mains electricity socket. Turn the
power and brushbar switches on. The switches are located
on the front of the carpet washer, above the clean water
tank. The power switch controls the vacuum motor and
pump, the brush switch only turns the rotating brushbar on
and off when the power switch is on (Fig.4/4).
Fig.4/4
Press on the handle release pedal and pull the cleaner back
into a reclined position (Fig.4/5).
Fig.4/5
While pressing the solution release trigger, push the
cleaner in a forward motion. Release the trigger and pull
the cleaner backwards over the same path to remove the
dirty water and solution from the carpet. Repeat if
necessary (Fig.4/6).
Advertisement
Table of Contents
