How To Assemble; How To Operate - Vax MAGNUM Instruction Manual

Vax VZL-401AA Magnum User Guide.qxd:VZL-401 User Guide
www.vax.co.uk

3. How to assemble

Handle Assembly
Slide handle piece into slot in the back of the unit. Insert
screws into holes indicated (Fig.3/1).
Fig.3/1
Tool Storage
Attach tools: (a) Clip the dusting brush into the holster at
the side of the cleaner with bristles facing out. (b) Insert
the crevice tool and extension wand into the slots on the
side of the cleaner (Fig.3/2). (c) Clip Turbo Tool onto the
front of the cleaner (Fig.3/2).
Fig.3/2

4. How to operate

Cord release
Turn Upper Cord Release for easy cord removal (Fig.4/1).
Cord Release
Fig.4/1
4
how to assemble / how to operate
All manuals and user guides at all-guides.com
11/3/09
Carpet height adjuster
The cleaning of carpet and rugs takes place at the nozzle.
When it is necessary to raise and lower the nozzle for
various carpet pile heights, place handle in upright
position and turn the carpet height adjuster to the
desired setting (Fig.4/2).
Height adjuster
Fig.4/2
NOTE: The nozzle will not move into the adjusted
position until the cleaner handle is lowered to the
operating position.
WARNING: This cleaner has a constantly
!
rotating brush bar which, when left in contact
with lino, parquet and other hard flooring could
potentially cause some damage to the floor surface.
NOTE: Vax recommends that you raise the height of
the brush bar when using this cleaner on lino and hard
flooring. Vax cannot be held responsible for damage to
these surfaces if the customer fails to take notice of
this recommendation.
On/Off Switch
Plug cord into electrical outlet. Turn cleaner on by
pressing the on/off switch located on the lower back
of unit.
Handle Release Pedal
To release handle, push the handle release pedal located
on the lower left side of the cleaner (Fig.4/3).
Fig.4/3
09:58 Page 4