Advertisement
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Important safety instructions
□
This portable lamp has a polarized plug (one blade is wider than the other) as a feature to reduce the risk
of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified electrician. never use with an extension cord
unless plug can be fully inserted. Do not alter the plug.
Care and Cleaning
□
Clean the lamp with a soft, dry cloth. Do not use any cleaners with chemicals, solvents, or harsh abrasives.
Troubleshooting
Problem
The bulb will not light.
The f use blows or a
circuit breaker trips when
the light is turned on.
Possible Cause
□ The bulb is burned out.
□ The power is off.
□ Did not insert plug into power
outlet.
□ The circuit breaker is off.
□ There is an exposed wire.
□ There are too many items on
one circuit.
Solution
□ Replace the light bulb.
□ Ensure that the power supply
is turned on.
□ Ensure that the plug is fully and
properly inserted into the power
outlet.
□ Ensure that the circuit breaker
is set in the on position.
□ Discontinue use of the lamp
□ Unplug other items on the circuit .
7
Advertisement
