Table of Contents Safety Information ............................2 Pre-Installation ............................3 Planning Installation ..........................3 Package Contents ..........................3 Assembly .............................. 4, 5, 6 Care and Cleaning ............................7 Troubleshooting ............................7 Safety Information □ Consult a qualified electrician with any IMPORTANT: Inspect the wire insulation for electrical questions you may have.
Pre-Installation PLANNING INSTALLATION Read all instructions before assembly. To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard. Inspect each part for defects that may have occurred during shipping. Keep your receipt and these instructions for proof of purchase. NOTE: This lamp requires the use of one 120V, 60H z, 6-Watt Edison LED bulb (included) or one 120V, 60Hz, 100 -Watt max, medium-base type A bulb (not included).
Assembly instructions Unpack the lamp & assemble lower pole □ Carefully organize and place all parts on a smooth, flat surface. line up all of the parts according to the assembly diagram. □ Screw the lower pole (H) to top of the base (I). Assemble the upper poles □...
Page 5
Assembly instructions (continued) Assemble the arm assembly and handle □ Pull the excess power cord through the base (I). □ Screw the arm assembly (D) to top of the upper pole (F). □ Screw the handle (E) to arm assembly (D). IMPORTANT NOTE: Please make sure the arm and socket face front as shown, if the arm and socket are not face front, adjust the...
Page 6
Assembly instructions (continued) Install the bulb □ Prior to installing the bulb, inspect socket for silica packet. If packet is present, then remove and throw away. Do not expose it to children or pets. □ Install one 120V, 60Hz, 6-Watt Edison LED bulb (A) (included) or one 120V, 60Hz, 100-Watt max, medium-base type A bulb (not included) into the socket of the light lamp .
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.