Advertisement
2.3 Connect to the gateway's network
1. Set your gateway to permit joining.
2. The LED panel light connected to the LED Lighting Driver will flash 4
times and then become steady after installation, indicating it is ready to join
the gateway's network (reset it if not).
3. The LED Lighting Driver will join the gateway automatically and the
brightness of the LED panel light will drop to 50% when successfully joined.
4. Now you can control the LED Lighting Driver remotely from your mobile
app.
Note: If the LED Lighting Driver fails to join the gateway's network within a
minute, simply reset the LED Lighting Driver and retry.
Reset. Turn ON, and turn OFF. Repeat this action three times using a
physically connected power supply. The LED panel light will start flashing
when reset successfully. Repeat the process if you fail to reset the device.
4
Advertisement
