Cruise Control Switches - PREVOST XL Series Instruction Manual

NOTE: When both radio and video systems are
on, speakers in the passenger area will be
connected to the video system, while the
speakers in the driver's area will be connected to
the radio.
14. Galley power switch (Optional)
Push down rocker switch to energize the galley's
electrical circuit.
15. Video volume (Optional)
Turn button clockwise to increase volume and
counterclockwise to decrease.
16. L.H. outside mirror control (Optional)
Turn pointer knob to the left for mirror head
adjustments and to the right for convex mirror
adjustments, then push down on either of the
button's four (4) sides to adjust the selected
mirror's viewing angle.
NOTE: If the mirror assies on your vehicle do not
include convex mirrors, only one (1) "Outside
Mirror Control" will be installed for both mirrors
(replacing items 16 & 17).
To operate, turn pointer knob to the left for L.H.
mirror adjustments and to the right for R.H. mirror
adjustments, then push down on either of the four
(4) sides to adjust the selected mirror's viewing
angle.
17. R.H. outside mirror control (Optional)
Turn pointer knob to the left for mirror head
adjustments and to the right for convex mirror
adjustments, then push down on either of the
button's four (4) sides to adjust the selected
mirror's viewing angle.
18. Diagnostic data reader connector
Datalink for DDEC 3, WT World Transmission
and ABS brakes.
19. Microphone jack
Driver's P.A. system microphone jack (see page
2-39 for details).

CRUISE CONTROL SWITCHES

Introduction
The cruise control is an automatic speed control
system that allows you to maintain a constant
cruising speed above 20 m.p.h. (32 km/h) without
depressing the accelerator pedal. The four (4)
control switches are located on the L.H. side
control panel (see page 2-5, item #2).
WARNING: Do not use the cruise control system
when driving conditions do not permit maintaining
a constant speed, such as in heavy traffic or on
roads that are winding, icy, snow covered,
slippery, or with a loose driving surface.
Setting vehicle speed
To turn on the system, push down "CRUISE"
rocker switch, set
accelerating to the desired speed, momentarily
press and release the "SET" switch, and then
remove your foot from accelerator pedal. This
sets the cruising speed and stores it in memory,
thus maintaining speed automatically.
NOTE: Cruise control system will not accept
speed settings, nor will the "RESUME" switch
operate, below approximately 20 m.p.h. (32
km/h).
Increasing set speed
Vehicle speed setting may be increased by one of
the following methods:
1. Press and hold the "RESUME" switch until the
desired speed is obtained.
"RESUME" switch will set the new higher speed.
2 - 6
CONTROLS/INSTRUMENTS
the vehicle speed
Releasing the
by