Seat Belts - PREVOST XL Series Instruction Manual

Seats from V.I.N. 2P9L33490S1001497
WARNING: Never try to adjust seat while driving
vehicle as this could result in loss of vehicle
control.
1. Rotate control knob to select desired
armresting angle. When not in use, raise armrest
parallel with backrest.
2. Lift lever to select proper adjustment angle of
backrest.
3. Pull handle up and slide seat forwards or
backwards to adjust distance between driver and
dashboard.
4. Pull handle up, and push down or pull up on
front of seat cushion to raise or lower the front
section of seat cushion.
5. For maximum suspension performance, push
down on knob until required weight is reached.
6. Press on "+" or "-" to respectively raise or
lower driver's seat.
7. Push on upper section of rocker switches to
inflate lumbar support bellows inside the seat
backrest, and push on lower section of rocker
switches to deflate bellows.
NOTE: Rear and front rocker switches are
respectively for lower and upper lumbar support
bellows.
Seat belts - Driver's seat
Each driver's seat is equipped with a retractable
seat belt as required by State, Provincial and
Federal regulations. To fasten, pull seat belt out
of the retractor and insert the latch plate into the
buckle until it clicks. No special adjustment is
required since the reel device is self-adjusting. If
seat belt operation becomes defective, report to
Manufacturer's Service Center.
18026C
NOTE: The seat belt must be pulled out slowly
and continuously, otherwise it will lock the reel
before the latch plate reaches the buckle. If this
happens, allow the belt to retract completely and
repeat the procedure correctly.
WARNING: A snug fit with the lap belt positioned
low on the hips is necessary to ensure motorist's
safety. Belt should not be worn twisted; avoid
pinching belt and/or belt hardware in seat
mechanism.
breakable objects, such as eyeglasses, pens, or
keys as these may cause injuries.
CAUTION: Never bleach or dry clean safety belt.
To unfasten belt, press red button in center of
buckle and allow belt to retract. If belt does not
fully retract, pull it out and check for kinks or
twists. Make sure that it remains untwisted as it
retracts.
2 - 28
CONTROLS/INSTRUMENTS
Do not wear belt over rigid or
18028