Calibration; Reset Default Settings; Close Plug-In After Scan - Canon N1220U User Manual

Calibration

Adjusts the white balance to the correct value so that all the colors are scanned
correctly. Calibration takes approximately 1 minute. If the color balance of a
scanned image is off-balance, select this option to calibrate the scanner input.

Reset Default Settings

Returns the preference settings and all other settings to the factory default
settings. The tables list the major default settings.
Scan Mode
Magnification
Unit
Basic Resolution
Control Panel Position
Image
Unsharp Mask
Descreen

Close Plug-in After Scan

This setting determines whether or not Plug-in Module CS-U closes automatically
after completion of the scanning job. After you install Plug-in Module CS-U, this
setting is set to on (Plug-in Module CS-U closes at completion of scanning). To turn
this feature off, open the [Preferences] menu and select [Close Plug-in After Scan].
This feature is switched off when you don't see it marked with a check mark. To
switch the feature on, click it again to show the check mark.
Color (Photos)
100%
Pixels
72 dpi
Center
Standard
Off
Off
27
S T E P 1