Table of Contents
Advertisement
Default source 1 to monitor 1, source 2 to monitor 2, and so on. Select the signal, and drag it to the source that will
set. For example, set signal 3 for source 13, as shown in the figure below:
Source 13 will be switched to signal 3, click source 1, then click "TAKE" icon
, the signal will be switched to
the corresponding monitor. Connect the signal to the corresponding output after setting.
Two ways can configure the matrix mode in Flex 16m (with Matrix Front Panel), using the XPOSE software or using
the buttons on the front panel to select the output through which the input signal will be delivered. If the user selects
Flex 16s, the matrix mode can only be configured from the XPOSE software.
2. Splitting Mode
Click the "Splitting Mode", and pop-up window as follow:
20/30
Advertisement
Table of Contents
